D-Link DVG-7111S - LAN Settings

DVG-7111S User’s Manual SETUP
D-Link Systems, Inc. 27
3-1-3 LAN Settings
SETUP → LAN Setup
Interface Mode: Select the VoIP TA serving as a Router with NAT or Bridge between WAN port and
LAN port without NAT.
Note: It is still accessible if LAN Interface Mode is Bridge.
LAN Port Address: Enter the LAN IP address of the VoIP TA. It is also the default gateway for DHCP
clients.
Subnet Make: Enter the subnet mask for DHCP clients.
Enable DHCP Server: This variable is to assign the IP address for the devices connected to LAN port
of the VoIP TA.
IP Pool Starting Address: Enter the starting IP address for the DHCP server's IP assignment.
IP Pool Ending Address: Enter the ending IP address for the DHCP server's IP assignment.
IP Pool Uses Other Default Gw: Check the box to assign different default gateway for DHCP clients.
IP Pool Default Gateway: Enter the new default gateway that is different from LAN IP of the VoIP TA.
IP Pool Subnet mask: Enter the new subnet mask.