D-Link DWA-510 - Configuring WPA;WPA2 Passphrase

38D-Link DWA-510 User Manual
Section 4 - Wireless Security
Configure WPA/WPA2 Passphrase
Using the D-Link Wireless Connection Manager
It is recommended to enable WPA-PSK on your wireless router or access point before configuring your wireless adapter. If you are
joininganexistingnetwork,youwillneedtoknowtheWPA-PSKpassphrasebeingused.
1. Open the Wireless Utility by double-clicking on the D-Link icon in your
systemtray(lower-rightcornerofscreen).
2. Highlightthewirelessnetwork(SSID)youwouldliketoconnectto
and click Connect.IfthenetworkisusingWPA-PSK,thescreen(as
shown to the left) will appear.
3. Enter the WPA-PSK passphrase exactly as it is on your wireless router
or access point. Click the Show text in the password field box to see
the passphrase. Unchecking it will hide it.
4. Click OK to connect to the network. Allow up to 30 seconds to connect.
IfyouwouldliketocreateanewnetworkandentertheWEPsettings,refertothenextpage.