Section 3 – Configuration
D-Link DWP-1010 User Manual 11
Status
Network
On this page you can view your router’s operating mode and related LAN network configuration. If you are
not sure which settings to use, please contact your Internet Service Provider (ISP). Note that the DWP-1010
requires a SIM card and active cellular internet service to connect to the Internet.
Shows the operating mode of the router, i.e. NAT or modem.
Link Status
Shows whether the mobile Internet connection is connected or
disconnected.
Displays the assigned IP address for your Internet connection.
Netmask
Displays the subnet mask for the above IP assignment.
Shows cellular signal strength as a percentage.
Displays the default gateway for the current connection.
IPv6 Network
Displays the public IPv6 address
Displays the IPv6 address that can be used only for communication with locally connected devices.
Modem
On this page you can view your router’s operating mode and related LAN network configuration. If you are
not sure which settings to use, please contact your Internet Service Provider (ISP). Note that the DWP-1010
requires a SIM card and active cellular internet service to connect to the Internet.
Modem Information
IMEI
The International Mobile Equipment Identity is a unique number
assigned to every mobile device.
Shows the current firmware version of the router.
Advanced
Infomation
The Advanced information displays the following additional
information:
Temperature: Detected temperature of the device.
Band Capability: Supported radio frequency bands.
Service Information
The status of the SIM card, i.e. ready or empty.
The status of the register, i.e. searching, ready or Displays the IPv6 address that can be used only for