D-Link DWP-1010

Section 3 – Configuration
D-Link DWP-1010 User Manual 21
System
This section allows you to configurate the system settings.
System Time
Device Mode
Item
Value setting
Description
Current Time
N/A
Shows the current time of the unit.
Sync Time
1. A must-fill item.
2. Atuo is selected by
default.
When Auto is selected, the unit will sync time via cellular cell and will switch
to NTP if cellular cell doesn’t provide time information.
When NTP is selected, the unit will sync time via NTP service.
Time Zone
1. A must-fill item.
2. GMT+00 :00 is
selected by default.
Select a time zone where this device locates.
Daylight Saving
1. It is an optional item.
2. Un-checked by default
Check Enable to activate the daylight saving function.
When enabled, users have to specify the Start Date and End Date for the
daylight-saving time.
Start Date
N/A
Start time of Daylight Saving.
End Date
N/A
End Time of Daylight Saving.
Action
N/A
Click Action to sync time immediately