D-Link DWR-932 - Add IP Filter

49D-Link DWR-932 User Manual
Section 3 - Conguration
If you selected Add New IP Filter:
Add IP Filter
Policy
Protocol
Source IP
Subnet
Source Port Number
Dest IP
Subnet
Destination Port
Number
Select whether the lter will Drop or Accept the
source IP address.
Select the protocol for ports that you want to allow or
deny access to. Choose between TC P, UDP or ICMP
or all of the above.
Enter a single port or a range of ports that you wish
to apply the changes to. Separate port numbers with
a comma.
Enter a two-digit subnet number.
Click the toggle if you wish to enter a range of port
numbers to allow or deny access to.
Type in the destination IP address.
Enter a two-digit subnet number.
Click the toggle if you wish to enter a range of port
numbers to allow or deny access to.