DXS-3326GSR Stackable Gigabit Layer 3 Switch
show ipfdb
Purpose Used to display the current IP address forwarding database table.
Syntax
show ipfdb <ipaddr>
Description This command will display the current contents of the Switch’s IP
forwarding database.
Parameters <ipaddr> - The user may enter an IP address to view the table by.
Restrictions None.
Example usage:
To view the IP forwarding database table:
DXS-3326GSR:4#show ipfdb
Command: show ipfdb
Interface IP Address Port Learned
------------ --------------- ---- ---------
System 10.0.0.1 1:13 Dynamic
System 10.0.0.2 1:13 Dynamic
System 10.0.0.3 1:13 Dynamic
System 10.0.0.4 1:13 Dynamic
System 10.0.0.7 1:13 Dynamic
System 10.0.0.30 1:13 Dynamic
System 10.0.34.1 1:13 Dynamic
System 10.0.51.1 1:13 Dynamic
System 10.0.58.4 1:13 Dynamic
System 10.0.85.168 1:13 Dynamic
System 10.1.1.1 1:13 Dynamic
System 10.1.1.99 1:13 Dynamic
System 10.1.1.101 1:13 Dynamic
System 10.1.1.102 1:13 Dynamic
System 10.1.1.103 1:13 Dynamic
System 10.1.1.152 1:13 Dynamic
System 10.1.1.157 1:13 Dynamic
System 10.1.1.161 1:13 Dynamic
System 10.1.1.162 1:13 Dynamic
System 10.1.1.163 1:13 Dynamic
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
config fdb destination_hit ports
Purpose To set specified ports as destination hit ports for the forwarding
database table.
Syntax
config fdb destination_hit ports [<portlist> | all] [enable |
disable]
Description This command will allow the user to define certain ports on the
Switch as destination hit ports. These destination hit ports will keep
FDB entries learned in the forwarding database table from aging out.
99
To Next Page
Loading...
