DXS-3326GSR Stackable Gigabit Layer 3 Switch
config fdb destination_hit ports
When a packet with a destination MAC address is received by one
of these ports, the packet will refresh the MAC address in the
forwarding database table, once a match has been made, so that it
will not age out.
Parameters <portlist> - Specify a port or ports to be enabled or disabled as
destination hit ports on the Switch. The port list is specified by listing
the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number, and
the highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated
by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical order.
<all> - Specifies that all ports on the Switch will be enabled or
disabled as destination hit ports.
[enable | disable] – Used to enable or disable the ports listed in the
<portlist> above to be destination hit ports.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure ports 1 to 5 as destination hit ports:
DXS-3326GSR:4#config fdb destination_hit ports 1:1-1:5 enable
Command: config fdb destination_hit ports 1:1-1:5 enable
Success.
DXS-3326GSR:4#
show fdb destination_hit ports
Purpose To view the destination hit port status of ports on the Switch.
Syntax
show
fdb destination_hit ports {<portlist>}
Description This command will allow users to view the destination hit port status
of ports listed in the portlist.
Parameters
{<portlist>} - Specify a port or ports to be displayed. The port list is
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
100
To Next Page
Loading...
