DXS-3326GSR Stackable Gigabit Layer 3 Switch
show ssh server
Description This command allows you to display the current SSH server setting.
Parameters None.
Restrictions None.
Usage Example:
To display the SSH server:
DXS-3326GSR:4# show ssh server
Command: show ssh server
SSH Server Status : Disabled
SSH Max Session : 3
Connection timeout : 120 (sec)
Authenticate failed attempts : 2
Rekey timeout : Never
Listened Port Number : 22
DXS-3326GSR:4#
config ssh user
Purpose Used to configure the SSH user.
Syntax
config ssh user <username 15> authmode {hostbased
[hostname <string 32> | hostname_IP <string 32> <ipaddr>} |
password | publickey]
Description This command allows you to configure the SSH user authentication
method.
Parameters <username 15> - Enter a username of no more than 15 characters
to identify the SSH user.
authmode – Specifies the authentication mode of the SSH user
wishing to log on to the Switch. The administrator may choose
between:
•
•
hostbased – This parameter should be chosen if the user
wishes to use a remote SSH server for authentication purposes.
Choosing this parameter requires the user to input the following
information to identify the SSH user.
hostname <string 32> - Enter an
alphanumeric string of up to 32 characters
identifying the remote SSH user.
hostname_IP <string 32> <ipaddr> - Enter
the hostname and the corresponding IP
192
To Next Page
Loading...
