DXS-3326GSR Stackable Gigabit Layer 3 Switch
config ssh user
address of the SSH user.
password – This parameter should be chosen if the user
wishes to use an administrator defined password for
authentication. Upon entry of this command, the Switch will
prompt the user for a password, and then to retype the
password for confirmation.
publickey – This parameter should be chosen if the user
wishes to use the publickey on a SSH server for authentication.
Restrictions Only administrator-level users can issue this command.
Example usage:
Command: config ssh user Trinity authmode password
To configure the SSH user:
DXS-3326GSR:4# config ssh user Trinity authmode password
Success.
DXS-3326GSR:4#
show ssh user authmode
Purpose Used to display the SSH user setting.
Syntax
show ssh user authmode
Description This command allows you to display the current SSH user setting.
Parameters None.
Restrictions None.
Example usage:
Command: show ssh user authmode
UserName
-------------------------- --------------------------
DXS-3326GSR:4#
To display the SSH user:
DXS-3326GSR:4#show ssh user authmode
Current Accounts: Authentication
Trinity Publickey
193
To Next Page
Loading...
