D-Link DXS-3326GSR - Packet Statistics Analysis

DXS-3326GSR Stackable Gigabit Layer 3 Switch
show 802.1x auth_configuration
port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order.
• all – denotes all ports on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the 802.1x rustication states (stacking disabled):
DXS-3326GSR:4#show 802.1x auth_configuration ports 1:1
Command: show 802.1x auth_configuration ports 1:1
802.1X : Enabled
Authentication Mode : Port_based
Authentication Protocol : Radius_EAP
Port number : 1:1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show 802.1x auth_state
Purpose Used to display the current authentication state of the 802.1x
server on the Switch.
show 802.1x auth_state {ports [<portlist | all>]}
Description
The show 802.1x auth_state command is used to display the
current authentication state of the 802.1x Port-based or MAC-
Syntax
209