DXS-3326GSR Stackable Gigabit Layer 3 Switch
show 802.1x auth_configuration
The following details will be displayed:
802.1x Enabled/Disabled − Shows the current status of 802.1x
functions on the Switch.
Authentication Protocol: Radius_Eap − Shows the authentication
protocol suite in use between the Switch and a RADIUS server.
Authentication Mode: Displays the type of authentication mode of the
802.1x function on the Switch. This field may read Port_based or
MAC-based.
Port number − Shows the physical port number on the Switch.
Capability: Authenticator/None − Shows the capability of 802.1x
functions on the port number displayed above. There are two 802.1x
capabilities that can be set on the Switch: Authenticator and None.
AdminCtlDir: Both/In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
OpenCtlDir: Both/In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
Port Control: ForceAuth/ForceUnauth/Auto − Shows the
administrative control over the port’s authorization status. ForceAuth
forces the Authenticator of the port to become Authorized.
ForceUnauth forces the port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure
and the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant
(user) to send EAP Request|Identiy packets.
SuppTimeout − Shows the time to wait for a response from a
supplicant (user) for all EAP packets, except for the Request/Identity
packets.
ServerTimeout − Shows the length of time to wait for a response from
a RADIUS server.
MaxReq − Shows the maximum number of times to retry sending
packets to the supplicant.
ReAuthPeriod − Shows the time interval between successive re-
authentications.
ReAuthenticate: Enabled/Disabled − Shows whether or not to re-
authenticate.
Parameters ports
• <portlist> − Specifies a range of ports. The port list is
specified by listing the lowest switch number and the
beginning port number on that switch, separated by a
colon. Then the highest switch number, and the highest
208
To Next Page
Loading...
