D-Link DXS-3326GSR - Page 225

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config 802.1x reauth ports
ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
 all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Specifies the MAC address of the
client the user wishes to add.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x reauthentication for ports 1-18:
DXS-3326GSR:4#config 802.1x reauth port_based ports 1:1-1:18
Command: config 802.1x reauth port_based ports 1:1-1:18
Success.
DXS-3326GSR:4#
config radius add
Purpose Used to add a new RADIUS server.
Syntax
config radius add <server_index 1-3> <server_ip> key
<passwd 32> [default | {auth_port <udp_port_number 1-
65535> | acct_port <udp_port_number 1-65535>}]
Description
The config radius add command is used to add RADIUS
servers to the Switch.
Parameters
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server
settings can be entered on the Switch. The lowest index number
will have a higher authenticative priority
 <passwd 32> − The shared-secret key used by the
RADIUS server and the Switch. Up to 32 characters can be
used.
acct_port <udp_port_number> − The UDP port number for
accounting requests. The default is 1813.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.
default − Uses the default UDP port number in both the
“auth_port” and “acct_port” settings.
auth_port <udp_port_number> − The UDP port number for
authentication requests. The default is 1812.
217