D-Link DXS-3326GSR - Page 230

DXS-3326GSR Stackable Gigabit Layer 3 Switch
radiusAuthClientMalformedAccessResponses 0
radiusAuthClientBadAuthenticators 0
radiusAuthClientPendingRequests 0
radiusAuthClientTimeouts 0
radiusAuthClientUnknownTypes 0
radiusAuthClientPacketsDropped 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_diagnostics
Purpose Used to display the current authentication diagnostics.
Syntax
show auth_diagnostics {ports [<portlist> | all]}
Description
The show auth_diagnostics command is used to display the
current authentication diagnostics of the Switch on a per port basis.
Parameters
ports <portlist> − Specifies a range of ports. The port list is specified
by listing the lowest switch number and the beginning port number
on that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list
range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port
4 − in numerical order.
all – Specifies that all ports will be viewed.
Restrictions None.
Example usage:
Command: show auth_diagnostics ports 1:16
EapLogoffsWhileConnecting 0
TimeoutsWhileAuthenticating 0
To display the current authentication diagnostics for port 16:
DXS-3326GSR:4#show auth_diagnostics ports 1:16
Port number : 1:16
EntersConnecting 0
EntersAuthenticating 0
SuccessWhileAuthenticating 0
FailWhileAuthenticating 0
ReauthsWhileAuthenticating 0
EapStartsWhileAuthenticating 0
EapLogoffWhileAuthenticating 0
222