D-Link DXS-3326GSR - Page 231

DXS-3326GSR Stackable Gigabit Layer 3 Switch
ReauthsWhileAuthenticated 0
EapStartsWhileAuthenticated 0
EapLogoffWhileAuthenticated 0
BackendResponses 0
BackendAccessChallenges 0
BackendOtherRequestsToSupplicant 0
BackendNonNakResponsesFromSupplicant 0
BackendAuthSuccesses 0
BackendAuthFails 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_session_statistics
Purpose Used to display the current authentication session statistics.
show auth_session_statistics {ports [<portlist> | all]}
Description
The show auth_session statistics command is used to display
the current authentication session statistics of the Switch on a
per port basis.
Parameters
ports <portlist> − Specifies a range of ports. The port list is
specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical
order.
all – Specifies that all ports will be viewed.
Restrictions
Syntax
None.
Example usage:
To display the current authentication session statistics for port 16:
223