D-Link DXS-3326GSR - Page 248

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config box_id
Purpose Used to configure box ID. Users can use this command to
reassign box Ids.
Syntax
config box_id {current_box_id <value 1-12> new_box_id
[AUTO | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12]}
This command will assign box IDs to switches in a stack.
Parameters current_box_id – Identifies the Switch being configured. Range is
1-12.
new_box_id – The new ID being assigned to the Switch (box).
Range is 1-12.

Restrictions Administrator privileges are needed to issue this command.
Description
auto – Allows the box ID to be assigned automatically.
Usage Example:
To change a box ID:
DXS-3326GSR:4#config box_id current_box_id 1 new_box_id 2
Command: config box_id current_box_id 1 new_box_id 2
Success.
DXS-3326GSR:4#
config box_type
Purpose Used to configure box type.
Syntax
config box_type {current_box_id <value 1-12> type [DGS-
3324SR | DXS-3350SR | DXS-3326GSR | BOX_NOTEXIST]}
Description This command will pre-assign the box type of switches in a stack.
Parameters current_box_id – Identifies the Switch being configured. Range is
1-12.
• DGS-3324SR – Name of a switch that can be set in the
stack.
•
•
• BOX_NOTEXIST – Identifies a switch which may be added
type – Enter the type of switch to be configured. The user may
choose between the following:
DXS-3350SR - Name of a switch that can be set in the
stack.
DXS-3326GSR - Name of a switch that can be set in the
stack.
240