D-Link DXS-3326GSR - Page 267

DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DXS-3326GSR:4#
config dst
Purpose Used to enable and configure time adjustments to allow for the
use of Daylight Savings Time (DST).
Syntax
config dst [disable | repeating {s_week <start_week 1-
4,last> | s_day <start_day sun-sat>| s_mth <start_mth 1-12>
| s_time <start_time hh:mm> | e_week <end_week 1-4,last>
| e-day <end_day sun-sat> | e_mth <end_mth 1-12> | e_time
<end_time hh:mm> | offset [30 | 60 | 90 | 120]} | annual
{s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time
<start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60
| 90 | 120]}]
Description DST can be enabled and configured using this command. When
enabled this will adjust the system clock to comply with any DST
requirement. DST adjustment effects system time for both
manually configured time and time set using SNTP service.
Parameters disable - Disable the DST seasonal time adjustment for the
Switch.
repeating - Using repeating mode will enable DST seasonal time
adjustment. Repeating mode requires that the DST beginning
and ending date be specified using a formula. For example,
specify to begin DST on Saturday during the second week of
April and end DST on Sunday during the last week of October.
annual - Using annual mode will enable DST seasonal time
adjustment. Annual mode requires that the DST beginning and
ending date be specified concisely. For example, specify to
begin DST on April 3 and end DST on October 14.
s_week - Configure the week of the month in which DST begins.
e_week - Configure the week of the month in which DST ends.
s_day – Configure the day of the week in which DST begins.
<start_week 1-4,last> - The number of the week
during the month in which DST begins where 1 is the
first week, 2 is the second week and so on, last is the
last week of the month.
•
•
•
<end_week 1-4,last> - The number of the week during
the month in which DST ends where 1 is the first
week, 2 is the second week and so on, last is the last
week of the month.
<start_day sun-sat> - The day of the week in which
DST begins expressed using a three character
259