D-Link DXS-3326GSR - Page 268

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config dst
abbreviation (sun, mon, tue, wed, thu, fri, sat)
e_day - Configure the day of the week in which DST ends.
s_mth - Configure the month in which DST begins.
e_mth - Configure the month in which DST ends.
s_time – Configure the time of day to begin DST.
e_time - Configure the time of day to end DST.
s_date - Configure the specific date (day of the month) to begin
DST.
e_date - Configure the specific date (day of the month) to begin
DST.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or
to subtract during the summertime. The possible offset times are
30, 60, 90, 120. The default value is 60.
Restrictions Only administrator-level users can issue this command.
<end_day sun-sat> - The day of the week in which
DST ends expressed using a three character
abbreviation (sun, mon, tue, wed, thu, fri, sat)
•
•
•
•
•
•
•
<start_mth 1-12> - The month to begin DST
expressed as a number.
<end_mth 1-12> - The month to end DST expressed
as a number.
<start_time hh:mm> - Time is expressed using a 24-
hour clock, in hours and minutes.
<end_time hh:mm> - Time is expressed using a 24-
hour clock, in hours and minutes.
<start_date 1-31> - The start date is expressed
numerically.
<end_date 1-31> - The end date is expressed
numerically.
Example usage:
To configure daylight savings time on the Switch:
DXS-3326GSR:4#config dst repeating s_week 2 s_day tue s_mth 4
s_time 15:00 e_week 2 e_day wed e_mth 10 e_time 15:30 offset 30
Command: config dst repeating s_week 2 s_day tue s_mth 4 s_time
15:00 e_week 2 e_day wed e_mth 10 e_time 15:30 offset 30
Success.
DXS-3326GSR:4#
260