D-Link DXS-3326GSR - Stacking Switches

DXS-3326GSR Stackable Gigabit Layer 3 Switch
To disable the Telnet protocol on the Switch:
DXS-3326GSR:4#disable telnet
Command: disable telnet
Success.
DXS-3326GSR:4#
enable web
Purpose
Used to enable the HTTP-based management software on the
Switch.
Syntax enable web <tcp_port_number 1-65535>
Description
This command is used to enable the Web-based management
software on the Switch. The user can specify the TCP port
number the Switch will use to listen for Telnet requests.
Parameters
<tcp_port_number 1-65535> − The TCP port number. TCP ports
are numbered between 1 and 65535. The “well-known” port for
the Web-based management software is 80.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable HTTP and configure port number:
DXS-3326GSR:4#enable web 80
Command: enable web 80
Note: SSL will be disabled if web is enabled.
Success.
DXS-3326GSR:4#
disable web
Purpose
Used to disable the HTTP-based management software on the
Switch.
Syntax disable web
Description
This command disables the Web-based management software
on the Switch.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
21