DXS-3326GSR Stackable Gigabit Layer 3 Switch
config rip
transmitted.
v2_only - Specifies that only RIP v2 packets will be
transmitted.
rx_mode − Determines how received RIP packets will be
interpreted – as RIP version V1 only, V2 Only, or V1 or V2.
This entry specifies which version of the RIP protocol will be
used to receive RIP packets. The Disabled entry prevents the
reception of RIP packets.
state [enable | disable] − Allows RIP to be enabled and disabled
on the Switch.
Restrictions
v1_only − Specifies that only RIP v1 packets will be
transmitted.
v1_or_v2 - Specifies that only RIP v1 or v2 packets will
be transmitted.
Only administrator-level users can issue this command.
Example Usage:
To change the RIP receive mode for the IP interface System:
DXS-3326GSR:4#config rip ipif System rx_mode v1_only
Command: config rip ipif System rx_mode v1_only
Success.
DXS-3326GSR:4#
enable rip
Purpose Used to enable RIP.
Syntax
enable rip
Description This command is used to enable RIP on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To enable RIP:
294
To Next Page
Loading...
