D-Link DXS-3326GSR - Page 332

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config ospf aggregation
settings.
Parameters
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> − The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to
the OSPF Area.
lsdb_type summary − Specifies the type of address aggregation.
advertise [enable | disable] − Allows for the advertisement trigger
to be enabled or disabled.
Restrictions Only administrator-level users can issue this command.
Usage Example
To configure the OSPF area aggregation settings:
DXS-3326GSR:4#config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Success.
DXS-3326GSR:4#
show ospf aggregation
Used to display the current OSPF area aggregation settings.
Syntax
show ospf aggregation {<area_id>}
Description This command will display the current OSPF area aggregation
settings.
Parameters
<area_id> − Enter this parameter to view this table by a specific
OSPF area ID.
Restrictions None.
Purpose
Usage Example
To display OSPF area aggregation settings:
324