D-Link DXS-3326GSR - Page 333

DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#show ospf aggregation
Command: show ospf aggregation
OSPF Area Aggregation Settings
Area ID Aggregated LSDB Advertise
Network Address Type
------------ --------------------- -------------- -------------
10.1.1.1 10.0.0.0/8 Summary Enabled
10.1.1.1 20.2.0.0/16 Summary Enabled
Total Entries: 2
DXS-3326GSR:4#
show ospf lsdb
Purpose Used to display the OSPF Link State Database (LSDB).
Syntax
show ospf lsdb {area_id <area_id> | advertise_router
<ipaddr> | type [rtrlink | netlink | summary | assummary |
asextlink]}
Description This command will display the current OSPF Link State Database
(LSDB).
Parameters
area_id <area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
advertise_router <ipaddr> − The router ID of the advertising router.
type [rtrlink | netlink | summary | assummary | asextlink] − The type
of link.
Restrictions None.
NOTE: When this command displays a “*” (a star symbol) in the OSPF
LSDB table for the area_id or the Cost, this is interpreted as “no area ID”
for external LSAs, and as “no cost given” for the advertised link.
Usage Example:
To display the link state database of OSPF:
325