D-Link DXS-3326GSR - Page 62

DXS-3326GSR Stackable Gigabit Layer 3 Switch
To configure the Switch location for “
HQ 5F ”:
DXS-3326GSR:4#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DXS-3326GSR:4#
config snmp system_name
Purpose Used to configure the name for the Switch.
Syntax
config snmp system_name {<sw_name>}
Description
The config snmp system_name command configures the name
of the Switch.
Parameters <sw_name> - A maximum of 255 characters is allowed. A NULL
string is accepted if no name is desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch name for “
DXS-3326GSR Stackable Switch ”:
DXS-3326GSR:4#config snmp system_name DXS-3326GSR
Stackable Switch
Command: config snmp system_name DXS-3326GSR Stackable
Switch
Success.
DXS-3326GSR:4#
enable rmon
Purpose Used to enable RMON on the Switch.
Syntax
enable rmon
Description
This command is used, in conjunction with the disable rmon
command below, to enable and disable remote monitoring
(RMON) on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
54