D-Link DXS-3326GSR - Page 75

DXS-3326GSR Stackable Gigabit Layer 3 Switch
show log
where x is the number of an entry in the log. The smallest number
(and therefore the earlier entry) will be first.
Restrictions None.
Example usage:
To display the Switch history log:
DXS-3326GSR:4#show log index 1-4
Command: show log index 1-4
Index Date Time Log Text
----- ---------- -------- -----------------------------------------------------
4 2000-03-02 01:54:53 Port 1:13 link up, 100Mbps FULL duplex
3 2000-03-02 01:54:53 Spanning Tree Protocol is enabled
2 2000-03-02 01:54:53 Unit 1, System started up
1 2000-02-28 06:06:09 Spanning Tree Protocol is disabled
DXS-3326GSR:4#
enable syslog
Purpose Used to enable the system log to be sent to a remote host.
Syntax
enable syslog
Description
The enable syslog command enables the system log to be sent
to a remote host.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To the syslog function on the Switch:
DXS-3326GSR:4#enable syslog
Command: enable syslog
Success.
DXS-3326GSR:4#
67