DIR-100 Ethernet Broadband Router
LAN Setup
Use this window to configure Router LAN IP Settings and DHCP Server Settings. When you are finished,
click the Save Settings button at the top of the window.
Network IP Settings menu
Router Settings
This section is used to configure the internal network settings of the Router. This IP address is private to
your internal network and cannot be seen on the Internet. The default Router IP Address is 192.168.0.1 and
the Default Subnet Mask is 255.255.255.0. The Local Domain Name is for the local Domain set on your
network, if you have given it a name previously. This field is for your personal use and unnecessary for
proper configuration of this window.
In addition, the Router can be configured to relay DNS from your ISP or another available service to
workstations on your LAN. When Enable DNS Relay is checked, the Router will accept DNS requests from
hosts on the LAN and forward them to the ISP (or alternative) DNS servers. Alternatively, you may also
disable the DNS relay and configure hosts on your LAN to use DNS servers directly. Most users who are
using the Router for DHCP service on the LAN and are using DNS servers on the ISP’s network, will leave
DNS relay enabled.
33
To Next Page
Loading...
Need help?
General
