DIR-100 Ethernet Broadband Router
About This User’s Guide
This user’s guide provides instructions on how to install the DIR-100 Ethernet Broadband Router and use
it to connect a computer or Ethernet LAN to the Internet.
Before You Start
Please read and make sure you understand all the prerequisites for proper installation of your new
Router. Have all the necessary information and equipment on hand before beginning the installation.
Overview
The procedure to install the Router can be described in general terms in the following steps:
1. Gather information and equipment needed to install the device. Before you begin the actual
installation make sure you have all the necessary information and equipment.
2. Install the hardware, that is, connect the cables to the device and connect the power adapter.
3. Check the IP settings on your computer and change them if necessary so the computer can access
the web-based software built into the Router.
4. Use the web-based management software to configure the device to suit the requirements of your
ISP account.
Packing List
Open the shipping carton and carefully remove all items. In addition to this Manual, ascertain that you
have:
• DIR-100 Ethernet Broadband Router
• Power Adapter
• Ethernet Cable
• Quick Installation Guide
• Manual on CD
If any of the above items are missing, please contact your reseller.
CAUTION: The Router must be used with the
power adapter included with the device.
iii
To Next Page
Loading...
Need help?
General
