D-Link Nuclias DNH-100 - Page 112

Nuclias Connect Software User Manual Appendix
Page 112
Nuclias Connect App
Standalone Access Point
Discover APs
The Discover AP function allows you to discover any access points in a L2/L3 wireless network.
From this page, you can discover standalone APs connected to the L2/L3 wireless network.
Tap to enable discovery on the L2 network.
Tap to enable discovery on the L2 network. Then enter an IP range in the provided From and To elds. Tap add (
) to create a
new IP range entry. Tap remove (
) to delete any dened range entries.
Once the range is dened, tap Next to initiate the discovery process.
Alternatively, tap Congure Access Point Proles from the bottom of the page to add or delete any local proles. See Congure
Access Point Proles.
After the scanning the network range, the Step 3 page will list any detected access points.
Tap the radio button next to the AP to select it. The selected local provision le will be pushed to the selected AP.
Tap Push Provision File to continue.