D-Link Nuclias DNH-100

Nuclias Connect Software User Manual Nuclias Connect Conguration
Page 53
Conguration Prole Settings Access Point
LAN
Nuclias Connect Performance
Under the LAN tab, users can enable or disable STP (Spanning tree). STP can help ensure that no loops are created when you
have redundant paths in your network. Navigate to Conguration > Prole Settings > [Site] > [Network] > Access Point >
Performance > LAN. Note that only access point with multi LAN ports can apply this setting.
Once the settings are updated, the conguration must be uploaded to the access points. See “Prole Settings” on page 69 for
further information.
2.4GHz/5GHz/5GHz 2 (Tri-Band)
Conguration Prole Settings Access PointNuclias Connect Performance
Once the settings are updated, the conguration must be uploaded to the access points. See “Prole Settings” on page 41 for
further information.