5 Configuration D-Link Web Smart Switch User Manual
Figure 56 – System > SNMP Settings > SNMP Community Table
Click Apply to create a new SNMP community, Delete to remove an existing community.
System > SNMP Settings > SNMP Host Table
This page is to configure the SNMP trap recipients.
Host IP Address: Specify the IP address of SNMP management host.
SNMP Version: Specify the SNMP version to be used to the management host.
Community String/SNMPv3 User Name: Specify the community string or SNMPv3 user name for the
management host.
Figure 57 – System > SNMP Settings > SNMP Host Table
Click Apply to create a new SNMP host, Delete to remove an existing host.
System > SNMP Settings > SNMP Engine ID
The Engine ID is a unique identifier used to identify the SNMPv3 engine on the Switch.
Input the Engine ID then click Apply to apply the changes and click Default resets to default value.
Figure 58 – System > SNMP Settings > SNMP Engine ID
System > SNMP Settings > SNMP Trap Settings
This page is to configure which traps will be sent to the SNMP manage hosts when event happens.
Select the event and click Apply to submit the changes.
34
To Next Page
Loading...
Need help?
General