xStack
®
DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Hardware Installation Guide
2
routers, switches and other networking devices. The dual speed ports use standard twisted-pair cabling and are ideal
for segmenting networks into small, connected sub networks for superior performance. Each 10/100 port can support
up to 200 Mbps of throughput in full-duplex mode.
In addition, the Switch has 2 SFP combo ports. These two-gigabit combo ports are ideal for connecting to a server or
network backbone. This stackable Switch enables the network to use some of the mo st demanding multimedia and
imaging a pplications concurrently with other user applications without creat ing bottlene cks. The b uilt-in co nsole
interface can be used to configure the Switch's settings for prio rity queuing, VLANs, and port trun k group s, port
monitoring, and port speed.
Features
• IEEE 802.3 10BASE-T compliant
• IEEE 802.3u 100BASE-TX compliant
• IEEE 802.1p Priority Queues
• IEEE 802.3x flow control in full duplex mode
• IEEE 802.3ad Link Aggregation Control Protocol
support.
• IEEE 802.1X Port-based and MAC-based Access
Control
• IEEE 802.1Q VLAN
• IEEE 802.1D Spanning Tree, IEEE 802.1W Rapid
Spanning Tree and IEEE 802.1s Multiple Spanning
Tree support
• Access Control List (ACL) support
• Single IP Management support
• Access Authentication Control utilizing TACACS,
XTACACS and TACACS+
• Dual Image Firmware
• Simple Network Time Protocol support
• MAC Notification support
• Asymmetric VLAN support
• System and Port Utilization support
• System Log Support
• Support port-based enable and disable
• Address table: Supports up to 16K MAC addresses
per device
• Supports a packet buffer of up to 1 Mbyte
• Supports Port-based VLAN Groups
• Port Trunking with flexible load distribution and fail-
over function
• IGMP Snooping support
• SNMP support
• Secure Sockets Layer (SSL) and Secure Shell
(SSH) support
• Port Mirroring support
• MIB support for:
• RFC1213 MIB II
• RFC14 93 Bridge
• RFC1907 SNMPv2 MIB
• RFC1757, 2819 RMON
• RFC20 21 RMONv2
• RFC1643, 2358, 2665 Ether-like MIB
• RFC2233, 2863 Interface MIB
• Private MIB
• RFC2674 for 802.1p
• RFC2618 RADIUS Authentication Client
• RFC2620 RADIUS Accounting Client
• RFC2925 Ping & Traceroute
• IEEE 802.1X MIB
• RS-232 DCE console port for Switch management
• Provides parallel LED display for port status such as
link/act, speed, etc.
• High performance switching engine performs forwarding and filtering at full wire speed, maximum 14, 881 packets/sec on
each 10Mbps Ethernet port, and maximum 148,810 packet/sec on 100Mbps Fast Ethernet port.
• Full- and half-duplex for both 10Mbps and 100Mbps connections. Full duplex allows the switch port to simultaneously
transmit and receive data. It only works with connections to full-duplex-capable end stations and switches. Connections to a
hub must take place at half-duplex
• Support broadcast storm filteringF
• Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
• Supports by-port Egress/Ingress rate control.
• Supports IP-MAC Port Binding.
• Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
• Supports STP Loopback Detection
• Safeguard Engine Support
To Next Page
Loading...
Need help?
General