www.d3engineering.com 585.429.1550
D3Engineering.com ▪ 585.429.1550
DesignCore™ TDA3x Product Family ▪ Quick Start Guide
Document No. 00C-131 ▪ Version 1.0 ▪ Release Date: 1/17/2019
4.0 Initial Setup
4.1 TDA3x and DM50x Document Applicable Kits: ISS Single-Camera Capture and Display
Note: Images shown are of RVP-TDA3x.
1. Connect the TDA3x system to a computer to access the debug Serial console. Connect the
provided USB-USB Micro B cable to the serial port, as shown below.
USB Micro B cable connected to the
Serial console debug port
2. Next, insert the provided Micro SD Card into the marked SD Card slot on the TDA3x system,
as shown below. The device will not boot without this card inserted.
Micro SD Card inserted into TDA3x system
To Next Page
Loading...