When the timer is close to zero, the “Drying in
progress” screen is displayed.
At this point, the door opens automatically and
remains half-open with a 10 degree angle.
WarningPlease note that hot steam is released when door
opens
Depending on the program, drying might take
several minutes and will not consume additional
energy.
The program is not completed yet; please wait a few
minutes for the drying to finish before removing
your dishes.
Warning Please note that some items are very
hot and could cause skin burns if removed too
soon. Daan Tech shall not be responsible for such
incidents, which occur when dishes are removed
before the offical end of the cycle.
When the program is completed, a signal sound occurs (unless you
have turned off the sound in “Settings”) and Bob will automatically go
into standby mode.
Upon completion of the program, leave Bob’s door open (10°) to prevent
unpleasant smell. This also reduces the energy consumption in the
standby mode.
Please note that some water
residue may remain on your
dishes if you do not wait for the
drying to nish.
At the end of the wash cycle
Drying in progress
Wait for sound signal for
cycle end
41
QUICK UTILIZATION GUIDE
To Next Page
Loading...
