ENGLISH
33
EVOSTA2, EVOSTA3 Hmax [m] Qmax [m
3
/h]
EVOSTA2 40-70/xxx M230/50-60
6,9 3,6
EVOSTA2 80/xxx M230/50-60
8 4,2
EVOSTA3 40/xxxM230/50-60
4 2,9
EVOSTA3 60/xxx M230/50-60
6 3,6
EVOSTA3 80/xxx M230/50-60
8 4,2
Table 3: Maximum head (Hmax) and maximum flow rate (Qmax) of EVOSTA2, EVOSTA3 circulators
7. MANAGEMENT
7.1 Storage
All the circulators must be stored in a dry covered place, with possibly constant air humidity, free from vibrations
and dust. They are supplied in their original pack in which they must remain until the time of installation. If this
is not the case, accurately close the suction and delivery mouth.
7.2 Transport
Avoid subjecting the products to needless impacts and collisions. To lift and transport the circulator use lifting
devices with the aid of the pallet supplied with it
(if contemplated).
7.3 Weight
The adhesive plate on the packaging indicates the total weight of the circulator.
8. INSTALLATION
Carefully follow the advice in this chapter to carry out correct electrical, hydraulic and mechanical installation.
Always switch off the mains power supply before working on the electrical or
mechanical part of the system. Wait for the warning lights on the control panel to go
out before opening the appliance. The capacitor of the direct current intermediate
circuit remains charged with dangerously high voltage even after the mains power has
been turned off.
Only firmly cabled mains connections are admissible. The appliance must be earthed
(IEC 536 class 1, NEC and other applicable standards).
Ensure that the voltage and frequency on the data plate of the EVOSTA2, EVOSTA3
circulator are the same as those of the power mains.
To Next Page
Loading...
Need help?
General
