Self inspect the motorcycle and have
regular maintenance inspections for
increased safety and the prevention of
accidents.
Self inspections before operation should be
performed an a daily basis prior to
operating the vehicle.
●Inspections of areas of concern.
●Fuel check
●Brake inspection
●Tire inspection
●Battery acid level inspection
●Throttle grip Inspection
●Clutch inspection.
●Drive chain inspection.
●Engine oil inspection.
●Lights and winker inspection.
●Back mirror inspection.
●License plate inspection.
Check areas which caused for concern
when last operating the vehicle.
Check gasoline to see if there is a
sufficient amount of gasoline to reach your
destination.
Refer to page 16 for refueling.
22
CAUTION
Observe safety rules when conducting
inspections.
●Exhaust gas contains harmful
substance such as carbon monox-
ide. Do not carry out inspections on
vehicle in closed places, or in
poorly ventilated places, with
engine running.
●Conduct inspections on flat, solid
ground with the stand erected.
●Be careful of burns when con-
ducting inspections immediately
after engine is stopped because the
engine and muffler are hot.
●Stop engine and remove the key
prior to the vehicle maintenance
service.
●If you are unable to correct trouble
even after you make adjustment or
correction, contact authorized
maintenance shops, dealers or
designated repair shops for
necessary inspection and repairs.
INSPECTION OF CONCERNED AREA
FUEL CHECK
SELF INSPECTIONS BEFORE OPERATION
**vl125(~47P) 02.11.5 4:33 PM 페이지22
To Next Page
Loading...
Need help?
General
