The front brake is the hydraulic disk type,
and the rear brake is the drum brake type.
As the brake pad wear, the brake fluid
level drops.
There are no adjustments to perform, but
fluid level and pad wear must be inspected
periodically.
The system must be inspected frequently
to ensure there are no fluid leaks.
[FRONT WHEEL]
<BRAKE LEVER FREE PLAY>
Lightly squeeze the brake levers until
tension is felt to check for an appropriate
amount of free play. No free play in the
brake levers or overly loose brake levers
are indication of a problem in the brake
system.
BRAKE LEVER FREE PLAY :
10~20mm
<BRAKE FLUID LEVEL>
Put main stand in upright position on a flat
ground and operate steel wheel, and check
fluid when the top of master cylinder cap
is level.
Check fluid level to see if it is below lower
level.
If fluid significantly low, it may indicate
fluid leakage on brake system. If this
happens, check fluid leaks or brake
system. If this happens, check fluid leaks
or damage on system and inspect joints
and clamps for looseness.
In addition, check hose and pipe protective
part to sec if they make contact with other
parts when you make left or right turn due
to vibration during travel.
23
CAUTION
●Brake is an important part which
protects your life. Make sure to
inspect brake prior to daily use.
WARNING
●Brake fluid may cause irritation.
Avoid contact with skin or eyes. In
case of contact, flush thoroughly
with water and call a doctor if your
eyes were exposed.
●
KEEP OUT OF REACH OF CHILDREN.
BRAKES
To Next Page
Loading...
Need help?
General
