34
[HEAD LIGHT, TAIL LIGHT]
Start the engine and make sure the lights
turn on. Also check to see if the lights are
damaged or if there is dirt on them.
[BRAKE LIGHT CHECK]
Turn the main switch to ON.
While separately operating the front and
rear brakes, check to see if the brake light
turns on. Also check to see if there is any
damage to the lens or if there is dirt on the
brake light.
[WINKER CHECK]
Turn the main switch to ON.
Check to see if all the winker in the front
and rear of the vehicle(including left and
right sides) are flashing properly, At the
same time, check to make sure that the
automatic sound signal of the winker is
working. Check also to see if any of the
lens are damaged or dirty.
Sit squarely on the seat and check to see if
you have a good view behind the vehicle
by looking at the rear view mirrors. Also
check for dirt and damage on the rear view
mirrors.
Check to see if there is any dirt or damage
to the license plate.
Also check to see if the license plate is
firmly secured to the vehicle.
CAUTION
●If you change engine oil imme-
diately after engine is stopped, be
careful of burns because the engine,
muffler and engine oil are still hot.
●Exercise caution not to allow dust
or other foreign matter to flow in
when refilling engine oil. If oil
overflows, wipe off oil clean.
●If oil level is lower or higher than
prescribed level, engine is
adversely affected.
●Do not mix oil with those of
different manufacturers or grade, or
do not use low-quality oil as it may
cause deterioration of oil, leading
to accidents.
●Clean the oil filter screen with fresh
cleaning oil every 4,000km.
● Be careful not to lose the oil filter
screen spring when assembling the
oil drain bolts.
LIGHTS AND WINKER
BACK MIRROR
LICENSE PLATE
**vl125(~47P) 02.11.5 4:34 PM 페이지34
To Next Page
Loading...
Need help?
General
