<BATTERY ACID REPLENISHING>
If the battery acid is insufficient, replenish
distilled water in the following sequence.
① Loosen the bolt and open the battery
band.
② Remove the battery breather tube from
the battery.
③ Remove the negative pole side cord
first and the positive pole side cord
next.
④ Remove the battery and open the
battery cap. Fill distilled water to near
upper level.
⑤ Tighten the battery cap accurately to
the vehicle and install battery. Make
sure, at this time, that side cord is
connected first, followed by side
cord.
28
BOLT
CORD
BOLT
BATTERY CAP
BATTERY
BREATHER TUBE
CAUTION
●Except designated attachment by
DAELIM MOTOR CO., LTD., do
not attach any extra lighting device,
because it may cause an early
discharging of battery.
●There 2 injection molded bolt-
shapes on the right side lower
cover. Take precautions not to
cause damage when removing the
cover.
WARNING
●When handling the battery stay
away from flammable materials.
●
KEEP OUT OF REACH OF CHILDREN.
UPPER
LEVEL
LOWER
LEVEL
**vl125(~47P) 02.11.5 4:34 PM 페이지28
To Next Page
Loading...
