BOOT LAMP
REAR APPLIQUE LAMP
The wi ring harness polarity
+, -
is
marked on the boot lamp as below.
Pay attention to the polarity in order not
to change each other when replacing the
boot lamp.
Colour of
Sectional area of
Polarity
.
.
wiring harness
wiring
harness
+
red
0.5 mm
2
-
grey 0.5 mm
2
4. Press the bulb, turn the bulb clockwise
and remove it from bulb holder.
5. Replace the bulb with the new one.
6. Press the bulb slightly, rotate the bulb
anticlockwise and insert the bulb into
the bulb holder.
7. When installing the bulb holder, insert
(g)
portion correctly and press
CD
por-
tion.
screw
-
2. Remove the wiring harness connector.
3. When removing the bulb holder, press
CD
portion and pull the bulb holder up-
wards.
1. Unscrew the two screws installed in the
upper side of lamp housing.
(f)
8
-
,
,
-I
1
8-<<>10
<f)
-<c>
ro
li)
8-22
To Next Page
Loading...
