5–10 ROOF, BACK PANEL AND REAR FLOOR PANEL
10.Apply the sealer.
• Apply the sealer to the rear side outer joint and
around the rear lamps areas of the rear panel.
• Apply the sealer to the extension rear floor panel
and rear panel joint.
11.Apply the undercoat.
• Undercoat to the joint and overlapped areas of
the rear floor under side.
12.Apply the paint.
CAUTION
• Ventilate when spraying paint. Most paint contains
substances that are harmful if inhaled or swal-
lowed.
Read the paint label before opening paint con-
tainer.
• Avoid contact with skin. Wear an approved res-
pirator, gloves, eye protection and appropriate
clothing when painting.
• Paint is flammable. Store in a safe place, and
keep it away from sparks, flames or cigarettes.
13.Install the related parts.
• Clean the trunk compartment.
• Install in the reverse order in which they were re-
moved.
14.Check and adjust.
• Check clearances and level differences.
• Check the trunk locking and unlocking condition.
• Check all operation.
• Check for water leaks in the trunk compartment.
NOTE: Use specified check sheet for operation
check properly.
To Next Page
Loading...
