7–4 FENDER, HOOD AND TRUNK LID
2. HOOD
2-1. REPAIR PROCEDURE
1. Remove the related parts.
• Washer hose and nozzles.
• Wiring harness and others.
2. Remove the hood.
• Remove the hood mounting bolts from two hinge
bows.
3. Preparation of the new hood.
• Preparation of the new hood and check damaged
areas.
Fig. 5
4. Apply the paint.
CAUTION
• Ventilate when spraying paint. Most paint contains
substances that are harmful if inhaled or swal-
lowed.
Read the paint label before opening paint con-
tainer.
• Avoid contact with skin. Wear an approved res-
pirator, gloves, eye protection and appropriate
clothing when painting.
• Paint is flammable. Store in a safe place, and
keep it away from sparks, flames or cigarettes.
5. Preinstall the hood.
• Fasten to the hood hinges bows at two places
with four bolts, carefully.
Fig. 6
To Next Page
Loading...
