FENDER, HOOD AND TRUNK LID 7–7
• Close the trunk lid and check the clearances and
level difference of trunk lid, side panel outers and
rear combination lamps.
Fig. 10
6. Tighten fully.
• After checking and adjusting the mounting posi-
tion, tighten all bolts fully.
7. Install the related parts.
• Wiring harness and solenoid valve.
• Lock set, latches and linkages.
• Install in the reverse order in which they were re-
moved.
8. Check and adjust.
• Clean the trunk compartment.
• Check clearances and level differences.
• Check the trunk lid locking and unlocking condi-
tion.
• Check for water leaks in the trunk compartment.
To Next Page
Loading...
