4
PC Component Recommended System Requirements
Graphics Intel HD Graphics, and later
RAM 16 GB, and larger
Monitor 1024 × 768, and higher
Browser Chrome 92 and newer
Browsers that do not support plug-in might have trouble displaying certain videos and images, or
downloading data in batches. The Camera reminds you when that happens.
Figure 2-1 Reminder
2.1.2 Device Initialization
The Camera is delivered uninitialized by default. You need to initialize it, and change its password
before further operations.
Before initialization, make sure that both PC IP, and device IP are on the same network segment,
otherwise it might fail to enter the initialization page.
Step 1 Set IP address, subnet mask, and gateway of PC, and device respectively.
●
If there is no router in the network, distribute IP address of the same segment.
●
If there is router in the network, configure the corresponding gateway, and subnet
mask.
The IP address is 192.168.1.108 by default.
Step 2 Use ping x.x.x.x (device IP address) command to check whether network is connected.
Step 3 Open browser, enter the IP address of the Camera in the address bar, and then press the
Enter key.
Step 4 Enter and confirm the password.
●
The new password must consist of 8 to 32 characters, and contain at least two types
from upper case, lower case, number, and special characters (excluding ' " ; :, and &).
To Next Page
Loading...
Need help?
General
