Dahua DHI-ITC215-PW6M-IRLZF-B - Configuring SNMP; Configuring IEEE802

47
2.5.3.7 Configuring SNMP
Prerequisites
●
Install the toll software for monitoring and managing SNMP (Simple Network Management
Protocol) device.
●
Get the corresponding version of MIB file from technical support.
Set SNMP and connect to the Camera through tool such as MIB Builder and MG-SOFT MIB Browser,
and then you can manage and monitor the Camera on the tool.
Procedure
Step 1 Select
Setting
>
Network
>
SNMP
.
Step 2 Select the version of SNMP to enable it.
●
V1
: The device can only process the information of version 1.
●
V2
: The device can only process the information of version 2.
●
V3
: Set the username, password and authentication type to enable safety verification
when the server accesses the device.
Step 3 Enter the IP address of the PC on which the MIB software is installed as
Trap Address
, and
leave other parameters as default.
Figure 2-60 SNMP
Step 4 Click
Confirm
, and then you can view the device configurations through MIB software.
2.5.3.8 Configuring IEEE802
Step 1 Select
Setting
>
Network
>
IEEE802
.