19
Table 2-9 Description of capture parameters
Type Parameter Description
General
Parameters
Snap Mode
●
Loop
: Use loop to take snapshots.
●
Video
: Use video to take snapshots.
●
Mix Mode
: Use both loop and video to take
snapshots.
Number of
Snapshots
It can take 1–2 snapshot(s).
Capture Direction
●
Approaching
: Only captures vehicles that
approach.
●
Departing
: Only captures vehicles that depart.
●
Two-way
: Captures vehicles that approach or
depart.
Same Plate
Filtering Time
Set the time interval during which one plate can
only be captured once.
Video Mode
Parameters
Only available
when the
Snap
Mode
is set to
Video
.
Scene Select
Small Vehicle
or
Large Vehicle
as needed.
UnlicensedMotor
Category
Click to enable the capture towards unlicensed
motor vehicles.
Licensed Vehicle
Frame Threshold
Configure the frame number of capturing licensed
vehicle.
1
(default) means to capture when
detecting one frame of licensed vehicle passing
detection area.
Unlicensed Vehicle
Frame Threshold
Configure the frame number of capturing
unlicensed vehicle.
10
(default) means to capture
when detecting 10 frames of unlicensed vehicle
passing detection area.
Loop Mode
Parameters
Only available
when the
Snap
Mode
is set to
Loop
.
Scheme
Set the scheme of snapshots triggered by the loop.
●
Single_in_1
: Lay single loop, and it will take a
snapshot when the vehicle enters a loop.
●
Double_in_1
: Lay double loops, and it will take
a snapshot when the vehicle enters the first
loop.
●
Double_in_2
: Lay double loops, and it will take
a snapshot when the vehicle enters the second
loop.
Loop Mapping
Select the corresponding relationship between
logical loop and physical loop.
●
When the scheme is
single_in_1
, only need to
select the physical loop corresponds to logical
loop 1.
●
You need to configure this in mix mode.
Loop1 Set the loop trigger mode.
To Next Page
Loading...
