29
Step 1 Select
Setting
>
ITC
>
RS-485
>
Trigger Mode
.
Step 2 Configure parameters.
The Camera supports multiple protocols.
●
DHRS
Figure 2-38 DHRS parameters
You can select external devices on the right side which support DHRS protocol.
Wiegand is only available for DHRS protocol.
●
RS-485 transparent transmission
The third party platform can control the RS-485 output of the Camera through RS-485
transparent transmission, and then you can connect external devices.
Trigger capture through transmitting capture command. To test the RS-485 transparent
transmission sending and receiving conditions, select
Hexadecimal Sending
, and then
click
Open
on the right side of
Receiving Area
.
Figure 2-39 RS-485 Transparent transmission
●
Serial port push
You can configure the serial port push information. The Camera pushes the snapshots
to the third serial collection device through RS-485.
To Next Page
Loading...
