85
Click drop-down list or text box to configure manufacturer, serial port and com address. Step 2
They shall be the same with actual manufacturer, serial port and com address (DIP
address) of video wall.
Click drop-down list at the top, to configure manufacturer and serial port together.
Click Save. Step 3
4.5.5.2.2 Screen ON/OFF
According to preset interval and time, the device sends ON/OFF commands to all screens
continuously, and ensures that each screen receives commands and turns ON/OFF.
Select Setup > Display Management > Screen Management > Screen ON/OFF. Step 1
The Screen ON/OFF interface is displayed.
Screen ON/OFF Figure 4-94
Select the Regional Switch Enable check box to enable the function. Step 2
Configure the parameters. Step 3
Table 4-20 Parameters description
Parameter Description
Switch Times The times of sending ON/OFF command.
Switch Interval Interval of sending ON/OFF command.
Screen Interval The interval for every screen to receive ON/OFF command.
Click OK. Step 4
4.5.5.2.3 Screen Timer
Configure fixed ON/OFF time of every screen. Within the configured period, every screen will be
turned ON/OFF at the fixed time.
Select Setup > Display Management > Screen Management > Screen Timer. Step 1
The Screen Timer interface is displayed.
To Next Page
Loading...