Dahua HDCVI series User Manual

HDCVI Series DVR User’s Manual
181
 Delete: Click it to remove selected channel group.
 Move up: Click it to move current selected channel up.
 Move down: Click it to move current selected channel down.
 Default: Click it to restore default setup.
Tips:
 Use mouse or Shift button to switch and button to enable /disable tour. means the tour
funciton is enabled and meas tour funciton is disabled.
 On the navigation bar, click or to enable/disable tour function.
Figure 4-123
4.10.5.2.3 Zero-channel Encoding
Click zero-channel encoding button, you can go to the following interface. See Figure 4-124.Here you
can enable and set zero-channel encoding function so that you can view several video sources at one
channel.
 Enable: This function is disabled by default. Check the box here to enable this function so that you
can control the zero-channel encoding function at the WEB.
 Compression: System default setup is H.264. You can set according to device capability.
 Resolution: The resolution value may vary due to different device capabilities. Please select from
the dropdown list.
 Frame rate: The frame rate value may vary due to different device capabilities. Please select from
the dropdown list.
 Bit Rate: The bit rate value may vary due to different device capabilities and frame rate setups.
Please select from the dropdown list.
 Save: Click the Save button to save current setup. If this function is disabled, you can not operate
zero-channel encoding function at the WEB, the video is black or null even you operate when the

Dahua HDCVI series Specifications

General

HDD Interface	SATA
Video Compression	H.264/H.265
Network Protocols	HTTP; HTTPS; TCP/IP; IPv4/IPv6; SNMP; UPnP; RTSP; UDP; SMTP; NTP; DHCP; DNS; DDNS; P2P
Remote Access	DMSS
Operating Temperature	-10 °C to +55 °C (+14 °F to +131 °F)
Operating Humidity	10% to 90% (non-condensing)