HDCVI Series DVR User’s Manual
Figure 5-31
Please refer to the following sheet for detailed information.
You can select DDNS protocol from the dropdown list and then
enable DDNS function.
Your self-defined domain name.
The user name you input to log in the server.
The password you input to log in the server.
Device sends out alive signal to the server regularly.
You can set interval value between the device and DDNS server
here.
Dahua DDNS and Client-end Introduction
1) Background Introduction
Device IP is not fixed if you use ADSL to login the network. The DDNS function allows you to access the
DVR via the registered domain name. Besides the general DDNS, the Dahua DDNS works with the
device from the manufacturer so that it can add the extension function.
2) Function Introduction
The Dahua DDNS client has the same function as other DDNS client end. It realizes the bonding of the
domain name and the IP address. Right now, current DDNS server is for our own devices only. You
need to refresh the bonding relationship of the domain and the IP regularly. There is no user name,
password or the ID registration on the server. At the same time, each device has a default domain name
(Generated by MAC address) for your option. You can also use customized valid domain name (has not
registered.).
3) Operation
Before you use Dahua DDNS, you need to enable this service and set proper server address, port value
and domain name.
Server address：www.dahuaddns.com
Port number：80
Domain name：There are two modes: Default domain name and customized domain name.
Except default domain name registration, you can also use customized domain name (You can input
your self-defined domain name.) After successful registration, you can use domain name to login
installed of the device IP.
To Next Page
Loading...
Need help?
General
