HDCVI Series DVR User’s Manual
Please check the box here to enable email function.
Input server address and then enable this function.
Default value is 25. You can modify it if necessary.
For the server supports the anonymity function. You can auto
login anonymously. You do not need to input the user name.
password and the sender information.
The user name of the sender email account.
The password of sender email account.
Authentication
(Encryption
mode)
You can select SSL or none.
Input email subject here.
System can send out the email of the snapshot picture once
you check the box here.
Input receiver email address here. Max three addresses.
It supports SSL, TLS email box.
The send interval ranges from 0 to 3600 seconds. 0 means
there is no interval.
Please note system will not send out the email immediately
when the alarm occurs. When the alarm, motion detection or
the abnormity event activates the email, system sends out the
email according to the interval you specified here. This
function is very useful when there are too many emails
activated by the abnormity events, which may result in heavy
load for the email server.
Please check the box here to enable this function.
This function allows the system to send out the test email to
check the connection is OK or not.
Please check the box to enable this function and then set the
corresponding interval.
System can send out the email regularly as you set here.
The system will automatically sent out a email once to test the
connection is OK or not .Before the email test, please save
the email setup information.
5.8.2.10 FTP
The FTP interface is shown as in Figure 5-34.
It is to set FTP IP, port and etc for remote storage.
Please refer to chapter 4.10.2.9 for detailed information.
To Next Page
Loading...
Need help?
General
