User's Manual
38
●
The number of cameras that can be added to the NVR varies with models.
●
The system supports adding camera through searching, manual add and batch
add. This section uses adding by searching as an example.
●
Initialize the camera before adding to the Device.
1) Click Search Device.
The devices found are displayed at the upper pane, excluding devices already
added.
Figure 5-7 Search device
●
To view the live image of a camera, click LIVE and then enter the username
and password. You can only view live images of cameras accessed through
private protocol.
●
To filter the remote devices, select device name from the Filter drop-down
list.
●
To filter out the uninitialized devices, click the Not Initialized tab, and then
you can initialize the devices remotely.
●
To view all remote devices added through plug and play, click the Not Auto
Connected tab. You can remove devices added through plug and play, and
they can be automatically added again after plug and play is enabled.
2) (Optional) Enable Plug and Play.
When Plug and Play is enabled, the Device automatically adds cameras on the
same LAN.
To Next Page
Loading...
Need help?
General
