Dahua PFS4218-16GT-190 - Page 24

Advanced Settings 17
Parameter
Description
Type
Two types: network and host.
Network: a segment of IP address.

Host: a specific IP address.

IP
Input the IP address of the host or the network.
Subnet Mask
Input the subnet mask.
Lease Time
Input the lease time of the address pool.
Domain Name
Configure the domain name.
Broadcast Address
Configure the broadcast address.
Default Router
Configure the default gateway of the address pool.
DNS Server
Configure the server IP address of the domain name
system.
NTP Server
Configure the NTP server IP address.
6) Click Save.
Configure the mode. Step 3
1) Click Mode tab.
The Mode interface is displayed. See Figure 4-14.
Mode Figure 4-14
2) Select the Mode as Enabled to enable DHCP Server.
3) Click Add VLAN Range.
A new record is added. See Figure 4-15.
Add VLAN range Figure 4-15
4) Input the VLAN range. For example, 2-4.
5) Click Save.
Configure the host IP address and the IP address segment. Step 4
1) Click Exclude IP tab.
Excluded IP interface is displayed. See Figure 4-16.